How GoConex Works
Wire-free switches, controllers, and dimmers.
Wireless Switches communicate to Controllers, which power connected electrical loads.
GoConex wire-free switches send “on”, “off”, and “dim” commands to controllers. Controllers send electrical current to connected electrical loads.
Controllers can be installed at any point in the electrical circuit.
Place a controller at the electrical panel, the load, or anywhere in between. The controller can power multiple loads up to its maximum rating.
Pairing Switches and Controllers Together
1. POWER THE CONTROLLER
Install a GoConex controller into an electrical box between the power and the load you want to switch. Connect the controller to power and to the lights/ motor you want to switch. If using more than one controller, group the controllers together before pairing them with switches.
2. PAIR CONTROLLER AND SWITCH
Pair the controller and the switch together by (1) pushing the pair button on the controller, then (2) squeezing both ends of the light switch. (3) Push the pair button again to lock the bond.
3. MOUNT SWITCH
Affix the light switch to any surface and finish it with a cover plate. Or, keep the switch portable and use it as a remote control.
Create Any Wireless Switch Combination
Create any switching combination at any time during or after construction.
Pair a Switch to Multiple Controllers
A switch can be paired with an unlimited number of controllers.
GoConex controllers and switches use bi-directional RF communication enable true wire-free switching. Once a controller is paired to a switch, it will remember the pairing even if power to the controller is turned off.
Smart Home and BMS Ready
GoConex controllers can be grouped together in a secure network for future smart home and building management system (BMS) functionality.
Group controllers together using the same steps as pairing a switch: press “pair” on the first controller, press “pair” on the second controller, then press “pair” again on the first to confirm the group addition.
Repurpose When Required
As needs change, so can your switches. Save precious resources like copper and plastic by reusing controllers and switches in new locations or configurations.
Press and hold the “Pair” button on your controller for 5 seconds to clear saved pairing information. Now re-pair the controller with new switches.